top of page
Applelec LED Light Sheet.jpg

Accessories

A range of accessories are available for our lighting solutons to ensure project aesthetics are met; these include controllers, dimmer switches, snap frames and fixings.

IMG_1325.jpg

CONNECT

All internal Applelec LED Light Sheet panels are fitted with the Connect wiring system. Suitable for simple or complex wiring solutions, Connect features a range of component parts that connect and disconnect with ease. Splitters include a 2-way splitter, 6-way splitter and a T-splitter which can be attached to any wire, anywhere in the system using a crimping tool. Extension wires in 500mm, 1000mm, 1500mm and 2000mm lengths can be added to a maximum length of 5000mm (up to 5A).

Applelec Connectivity lighting design
Applelec Power Supply for lighting design schemes

POWER SUPPLY

 

Each LED Light Sheet panel is supplied with a power supply to suit project requirements. For indoor applications, each standard unit is fitted with a power unit with a three pin plug. For IP67 rated panels, an IP66 driver is supplied for hard wiring. Alternatively a bare end wire up to a maximum length of 3 metres may be fitted to the unit.

POWERBOXES

To minimise wiring of multiple panel projects, Powerboxes provide a simple solution. Available in 300W for standard white LED Light Sheet, 240W for dimmable panels and 216W for RGB projects, the Powerboxes help reduce wiring time onsite. With up to five fused 60W outlets (per 300W Powerbox), spider connectors can further increase the number of panels powered, dependent on their combined load.

Applelec power boxes for lighting design
Applelec Spider Connectors architectural lighting solutions

SPIDER CONNECTORS

 

Allowing up to four Applelec LED Light Sheet panels (LED load dependant) to be linked together and run from a single power supply, Spider Connectors are available in two wire lengths. The short four-port Spider links together panels positioned in close proximity, whilst the long Spider features four-ports each with a wiring range of 1500mm. Efficiency is maximized by utilising the LED load on the driver, whilst reducing the number of driver units required overall.

PORTABLE BATTERIES

For architectural lighting solutions located in areas without easy access to power, a range of portable, rechargeable batteries is a useful option. Fully waterproof and suitable for exterior locations, these 12v lithium polymer batteries are available in a range of sizes including small hand-held units. With a built in fuel gauge, the lightweight batteries are available in 4Ah, 8Ah, 10Ah, 14Ah and 22Ah sizes.

Architectural lighting solution batteries
bottom of page